Description
These Toyota Sienna rear door speaker wire harness adapters will make installing your new aftermarket speakers / tweeters fast and easy!
We designed this harness along with our dash tweeter harness to work with a MATCHED set of component speakers. Get true component speakers without any cutting or splicing your factory wiring.
NOTE: We highly recommend a matched component set that presents 4 Ohms. If you install two sets of coaxial speakers, you are going to drop the impedance (ohms) to 2 ohms in most cases. Your head unit is NOT designed to handle a 2 ohm load.
We offer a number of different options to fit any budget. While you are here check out our many audio products for your Toyota Sienna.
We designed these harnesses to work with our plug and play amplifiers that connect directly to your stock stereo. The amps will boost the signal coming from your stock head unit from 15 watts to 100 watts RMS. The leads (wires) are 36″ long and made with heavy 16 gauge wiring. Our plug and play amps will work with most aftermarket head units (stereos) as well.
2 – Tweeter Harness Adapters
These speaker harnesses will make adding aftermarket speakers quick and easy. Similar harnesses on the market are generally six inches long and only 18G wire. Our harnesses are 36” and a full 16 gauge wire.
