Toyota Tacoma Front Door PowerBass S60C Component Speaker Installation Kit
On a budget but still looking for a component speaker setup? . The PowerBass S60C Component Speakers are an affordable solution to upgrade the speakers in your Toyota Tacoma. Their high efficiency provides incredible detail and very high output levels while producing rich well-balanced sound with excellent tonal characteristics.
This kit includes discounted pricing on the following items needed to install the PowerBass S60C speakers in the front doors of your Toyota Tacoma:
2 – PowerBass S60C Mid Range Drivers
2 – PoweBass S60C tweeters
2 – PowerBass Crossovers
2 – Front Door 6.5″ budget friendly speaker mounts (Driver & Passenger Side) – this is a pair of speaker mounts.
2 – tweeter mounts – custom sized.
2 – Speaker Wire Harness Kit
2 – Tweeter Wire Harness Kit
2005 – 2015 (Generation 2) Tacoma – If you are installing our plug and play amplifier(s), we highly suggest using the tweeter harness adapters (as shown in installation video below). The crossover mount adapters make it easier to mount your crossover below the door panel You can use zip ties to accomplish the same task.
2016 – 20xx (Generation 3) Tacoma -If you are installing our plug and play amplifier(s), we highly suggest using the tweeter harness adapters AND the speaker harness adapters (as shown in installation video below). The crossover mounts is not required since you will be installing the crossover inside the vehicle. Be sure to watch the video below.
If you are planning to power your speakers with the stock wiring (using the stereo to power the speakers), you will want to add the speaker wire harness adapter kit to your order. This kit will allow you to plug into the the factory wiring without any cutting of splicing AND will make it much easier to return your Toyota Tacoma back to factory if you ever trade in or sell. If you are planning to install an amplifier, you will be running heavier gauge speaker wire to your speakers so you will NOT need wire harnesses.
Thank you for taking the time to check out our products for your Toyota Tacoma. We sincerely appreciate the opportunity to do business with you!
- 6.5″ Component Speaker System
- Black 2-layer Paper, DDC (Dynamic Damping Coating) Cone
- Double Pressed Treated Foam Surround
- 10 oz. Motor Structure
- Shallow Mounting Depth
- 0.75″ Pure Silk Dome Tweeter w/Neodymium Magnet
- EFF Motor Structures (Efficient Flux Field)
- Rigid Tooled Basket With Flat Black Finish
- Computer Aided External 12dB 2-way Crossover Network
- Nominal Impedance: 4-ohm
- Material: 2 layer paper DDC cone / silk dome tweeter
- Sensitivity (1W / 1M): 90 dB
- Mounting Depth: 2.3 in
- Size: 6.5 in
- Frequency Response: 60 Hz – 20 kHz
- Power Handling (RMS/Peak): 70 / 210 watts
NOTE: The included crossover MUST be used in the installation. Failure to use the crossover will result in speaker damage that is not covered under warranty. Be sure you tune your amp!
Manufacturer’s Warranty: 1 year.
Below are instruction on how to install the speakers using your stock wiring. If you are using our plug and play setup, you will probably install them similar to the video below. If you are running new speaker wire, you will probably install your crossovers either in the center console or in your storage compartments under the rear seats.
2005 – 2015 Component Speaker Installation
2016+ Component Speaker Installation
How to remove the door panels: