2019+ Toyota Avalon Add amplifiers to factory stereo Plug & Play Harness Sound Processor Factory Integration

$19.99

• THIS PRODUCT IS FOR NON JBL ONLY!
• EXAMPLE INSTALLATIONS / INSTRUCTIONS BELOW
• THIS HARNESS WILL CONNECT BEHIND THE HEAD UNIT
• PLEASE SEE DESCRIPTION BELOW FOR DETAILED INFORMATION.

SKU: N4-77-EZAH10-3A Category:

Description

Be sure to check out our other Plug & Play harnesses designed for your Avalon audio system. They will make installing new aftermarket speakers – FAST & EASY with ZERO cutting or splicing of factory wires.

-17 Foot leads. (17 x 16 = 272 Feet Total Wiring Included)

-16 gauge (thicker than 18G) speaker wire to handle the additional power – (Harness 1 Connect to your AMP Speaker OUTPUT)

-18 gauge signal wire (Harness 2 Connect to your LOC / DSP)

-Industry Standard 12V Color Coded input / output Molex connectors (for plug and play system)

-Easily modified to work with just about any aftermarket amplifier.

NOTE: This harness system was manufactured to work with tacotunes.com plug and play amplifiers. You can cut off the blue/black Molex plugs and connect them to a number of different brand amplifiers. However, due to the large number of amp brands / models we cannot help with the installation process. To make the installation easier, we have listed the color/purpose of each wire in the harness system.

DOES NOT SUPPORT FACTORY INSTALLED JBL AUDIO SYSTEMS!

IMPORTANT: The factory wiring was not designed to handle a lot of power. We do not recommend more than 100 watts (RMS) on your stock wiring. Most amps are rated at 14.4 volts for their ratings. Toyota charging system is only 13.6. So you can use an amp rated at 100 watts RMS. We HIGHLY suggest the use of a quality LOC/DSP/Sound Processor.

This harness is setup to provide a 12V constant power to your LOC/Sound Processor. It also includes Accessory Wire that will turn your aftermarket audio gear on / off.

RED = Accessory Remote Turn On/Turn Off

YELLOW = 12V Constant. This is used to power your LOC/DSP/SOUND PROCESSOR. DO NOT ATTEMPT TO POWER YOUR AMP / POWERED SUB WITH THIS WIRE.

NOTE: ALL amps / powered subwoofers will require fused power coming directly from your car battery. A relay MIGHT be required when using 2 or more amplifiers.

Wiring Schematic:

HARNESS 1 BLACK PLUGS (Output to speakers):

These black Molex Plugs connect directly to our TXD line of amplifiers OR can you can remove then and integrate just about any aftermarket amplifier.

Left Front Speaker: White (+) White/Black (-)

Right Front Speaker: Gray (+), Gray/Black (-)

Left Rear Speaker: Green (+), Green/Black (-)

Right rear Speaker: Purple (+), Purple/Black (-)

Left Front Speaker: White (+) White/Black (-)

Right Front Speaker: Gray (+), Gray/Black (-)

Left Rear Speaker: Green (+), Green/Black (-)

Right rear Speaker: Purple (+), Purple/Black (-)

Red Wire – Remote Turn on wire

Yellow Wire – Constant 12v (Do not use to power amps! this is for sound processors ONLY)

EXAMPLES: